Everybody needs help from time to time

Added: Korinna Houser - Date: 01.10.2021 02:38 - Views: 22777 - Clicks: 4012

Moderator: VelvetGeorge.

Everybody needs help from time to time

Post by demonufo » Sat Aug 14, pm. Post by flemingmras » Sat Aug 14, pm. Post by demonufo » Sun Aug 15, am.

Everybody needs help from time to time

Post by flemingmras » Sun Aug 15, am. Post by demonufo » Sun Aug 15, pm. Post by Tone Junkie » Sun Aug 15, pm. Post by neikeel » Mon Aug 16, pm.

Everybody needs help from time to time

Post by demonufo » Sun Aug 29, am. Metropoulos Forum The place for vintage amp discussion. Everybody needs help from time to time New here? Need help? Don't know where to post? Post here. Post Reply. Contact demonufo. The one I intend to omit is the one that goes directly to the filter cap. I would instead connect the filter cap to pin 6 on V5. Or maybe it might be neater to omit the other one and do the same. Anybody see anything I'm missing? The only reason I wish to do this is space is now at a premium on my next board install, and I doubt I can fit three wires to one turret.

The choke is already going to have to come up through the turret from underneath, and the le on my resistors are pretty wallopingly huge. Thanks for looking guys. So I like purple, okay!!!!!! Contact flemingmras. Re: Everybody needs help from time to time One of them being the choke, the other going to the screen string while the 3rd goes to the 8. There's just that fine line between stupid and clever - Nigel Tufnel. Don't think my choke will reach the filter directly though, since it's one of the few original components still in this amp. At least you've set my mind at ease.

I couldn't think of a single electrical reason why not, but just checking whether or not there were any potential noise issues in changing things around. Quote Post by Tone Junkie » Sun Aug 15, pm Were did you find your copper leaded resisters at and what kind are they. Quote Post by demonufo » Sun Aug 15, pm Tone Junkie wrote: Were did you find your copper leaded resisters at and what kind are they. Have you tried those yellow phillips one yet? Quote Post by demonufo » Sun Aug 29, am neikeel wrote: If they are for your PI output couplers why not use 0.

Everybody needs help from time to time Everybody needs help from time to time

email: [email protected] - phone:(178) 441-8510 x 4174

'Everybody Needs a Break.' Fleetwood Mac Skateboarder Reflects on His Viral Fame and Helping People Chill Out for a Bit